Skip to content Skip to sidebar Skip to footer

How To Clean Furnace Flame Sensor


How To Clean Furnace Flame Sensor. Reconnect the wire to the sensor terminal. The flame sensor is usually a short rod that sticks out in front of where the flame would be.

Flame Sensor cleaning on a furnace YouTube
Flame Sensor cleaning on a furnace YouTube from www.youtube.com

The furnace flame sensor helps prevent explosions that could. A faulty flame sensor implies that you will need to purchase a new sensor that is either compatible with your furnace model or a. A furnace flame sensor is a device that senses the presence of a flame in the furnace.

As Long As The Component Senses The Flame, It Sends A Message To The Main Furnace Control Board Telling It To Keep The Main Burner On And The Gas Valve Open.


Because the furnace works on flammable gas, we need to take care of it properly. If the sensor does not detect an active flame, then it will shut the furnace off to avoid a potential gas leak. Somewhere in front of the burners is the flame sensor.

Over Time, The Dust Or Dirt On The Furnace Burns Up And Cause To Carbon Buildup On It's Flame Sensor.


Reposition the access panel and secure it with the mounting screws or retaining knobs as required. How to clean flame sensor? Then cover and reinstall the gas furnace properly.

How To Paint Kitchen Cabinets.


For a furnace that is cycling on and off, the problem is usually the flame sensor. 1/4 inch hex driver or wrench. Remove the screws to drop the sensor box from the bracket.

The Flame Sensor Is Usually A Short Rod That Sticks Out In Front Of Where The Flame Would Be.


If the sensor does not detect a flame, it will cause the furnace to shut down. The sensor is held in place with one or two sheet metal screws attached to a bracket. Remove the flame sensor wire.

A Faulty Flame Sensor Implies That You Will Need To Purchase A New Sensor That Is Either Compatible With Your Furnace Model Or A.


Replacing the faulty flame sensor. Unscrew the single screw holding the sensor to the burner housing using a phillips screwdriver or a socket wrench depending on which type of screw head it has. Then, use a clean paper towel to wipe clean any dust left behind by the sanding.


Post a Comment for "How To Clean Furnace Flame Sensor"